How to send personalized bulk email without landing in spam
Domain authentication, list hygiene, and personalization that keep cold email in the inbox.
Sending the same email to hundreds of people is easy. Getting it into the inbox, and getting replies, is the hard part. Mailbox providers like Gmail and Outlook judge every message on who sent it, whether the domain is authenticated, how recipients react, and whether it looks like a mass blast.
This guide walks through the setup and habits that keep bulk email out of spam, then shows how to run a personalized campaign in ReachConvert.
Before you begin
- A domain you control, so you can add DNS records.
- An AWS account for Amazon SES, which ReachConvert uses to send email.
1. Authenticate your sending domain
Unauthenticated email is the most common reason bulk mail lands in spam. Set up three DNS records for the domain you send from:
SPF
Lists the servers allowed to send for your domain. With SES, set a custom MAIL FROM domain so SPF aligns with your From address.
DKIM
Cryptographically signs each message. Turn on Easy DKIM when you verify your domain in SES and add the CNAME records it gives you.
DMARC
Tells receivers what to do when SPF or DKIM fails. Start with p=none and a reporting address, then tighten it once reports look clean.
Gmail and Yahoo bulk sender rules
Since February 2024, Gmail and Yahoo require bulk senders to authenticate with SPF and DKIM, publish a DMARC policy, make unsubscribing easy, and keep spam complaint rates low. Set this up before you send at volume.
2. Leave the SES sandbox and warm up
- 1New SES accounts start in the sandbox, which can only send to verified addresses. Use it to test, then request production access from the SES console.
- 2Start with small daily volumes from a new domain or address and increase them gradually over a few weeks.
- 3Send your first campaigns to the contacts most likely to engage. Early replies and opens build sender reputation.
3. Keep your list clean
Bounces and spam complaints damage your reputation faster than anything else. AWS recommends keeping your bounce rate below 5% and your complaint rate below 0.1%, and may pause sending from accounts that go well beyond those levels.
- 1Verify addresses before importing a purchased or scraped list, and remove anything that fails.
- 2Remove hard bounces after every campaign. History shows which recipients failed.
- 3Give every email a clear way to opt out, and remove people who ask straight away.
4. Personalize beyond the first name
A first name in the greeting no longer convinces anyone. Personalization that works refers to something specific about the person or their company.
In ReachConvert, every column in your contact import becomes a template variable, so you can reference a person’s role, industry, or a note you wrote about them. Signal variables go further and reference a real event, like a funding round or a new product.
Subject: {{company}} + quick idea for {{jobTitle}}s
Hi {{firstName}},
I noticed {{company}} works in {{industry}}. Teams like yours usually ...Send your first campaign in ReachConvert
- 1Open Settings, add your SES access key, secret, region, and verified sender address, then click Test SES.
- 2Import contacts under Contacts, mapping your columns so they become template variables.
- 3Create a template under Email Campaigns, by hand or with AI generation.
- 4Create a campaign, launch it to a small directory of your own addresses first, and check the result.
- 5Launch to the real audience, then watch delivery, opens, and replies on the Dashboard.
Judge results by replies
Some mail apps, such as Apple Mail with Mail Privacy Protection, load tracking pixels automatically, which inflates open rates. Reply rate is the more reliable signal of what is working.
Tips
- Send cold outreach from a separate subdomain, such as mail.yourcompany.com, so it cannot harm your main domain’s reputation.
- Use the Template Performance table on the Dashboard to retire templates with low reply rates.